November 2006


Options: Use Proportional Font
Show Text Part by Default
Condense Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
CSUF Help for Listserv <[log in to unmask]>
Dorena Perry <[log in to unmask]>
Tue, 21 Nov 2006 21:19:54 +0100
text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit
CSUF Help for Listserv <[log in to unmask]>
text/plain (131 lines)
Virginia has uploaded some new software for you!

Click here to view available updated software from Virginia:

        example, you can create a console xterm by typing xterm -C,
        the stream of data sent to the printer.
sending it so we could get our hands on it a little quicker.
#  Installed in /usr/local/libexec/psdf's into the network address of your own SLIP subnet (be sure
bootp, tftp and NFS services available.
vendors, including Western Digital and Intel.  Other vendors reverse-
        Discussions about the use of FreeBSD-current
The terminators discussed in the previous chapter need power to
Bus-mastering is found in some SCSI adapters and other high-
under /compat/linux, with the names in the first column as symbolic  DEPENDS
device        sio2 at isa? port "IO_COM3" tty irq 5 vector siointr
                        ldd               ldso
recognizable prompt.    If the data rates do not match, getty sees
        CR characters to return the print location to the left edge of
FTP Active
minimal difficulty for commercial vendors, but is a serious problem
                 Bit 6     Set Break
options, respectively.
profound sense of frustration. A combination of factors works against
example is the files that comprise these handbook pages-they have been
four categories, or your port requires to have the source of the other
33:6672343, tf_cs = -266469368, tf_eflags = 66066, tf_esp = 3072, tf_\
To configure your kernel to include DDB, add the option line
Note that if you have set up access to a printer remotely (see section
www.freebsd/; otherwise, check the place where you found
        to type in capitals, who is drinking too much coffee, where the
Special note: Before invoking the installation, be sure that
makers of PC-clones and add-on cards have created two additional areas
1:Script started on Fri Dec 30 23:15:22 1994
        byte receive buffer.  This original UART has several race
16.2.  Who needs FreeBSD-stable?
If you need more information about these terms and data communications
The DVI filter is a shell script named /usr/local/libexec/psdf.  Here
FreeBSD is available in both source and binary form on CDROM and via
The LPD spooling system supports one other type of filter that we
file comes from the af capability in /etc/printcap, and if not
        wrote ctm_[rs]mail, much appreciated.
legitimate characters are received, and, in a typical configuration,
a device's unit number has no relationship with its target ID on the
3. Type
The interface (Netif column) that it specifies to use for localhost is
specifications included in RS232-C.
         115 ??  I      0:00.10 /usr/libexec/getty V19200 ttyd1
16:#6  0xf01040a0 in db_trap ()
o  It can send jobs over the network to another LPD spooler on another  BUILD_DEPENDS
package.  Installing this package gives us the program we need,
the X-window system, eight megabytes of RAM is the recommended
Contributed by Guy Helmer <>.
rose: Permission denied
# Additions for a V.32bis Modem
Now, each of the conversion filters and the text filter can call this
For our simple printer setup, the text filter can be a small shell
6.4.2.  What does IPFW allow me to do?
While on the subject of translations, I have seen one controller type
iteration count is decremented after each successful login to keep the
Also, refer to programs/files from other ports with the variables
port.  Do not change the 05 setting.
desired quota limits, the following command can be used to duplicate
o  Q. I thought you were supposed to use packages to install extra
Expiration date (enter yyyy-mm-dd) [ 2000-01-01 ] ?
The kernel is currently being moved to a better organization of the
(the 9FX series) are pretty fast cards as well, and are supported by
trap cleanup 1 2 15
Terminators come in various incarnations, with more or less
Independent Disks) arrays the TCQ function is indispensable to take
Netboot can be compiled to support NE1000/2000 cards by changing the
        for the sc0 device are often not available -- ``vt100'' should
        option has effect only when used with the -p option.
will check for an executable called `unzip', and descend into the
sio12: type 16550A (multiport)
sio1: type 16550A
        exit 2
hexadecimal from the previous port, thus the 100h, 108h, 110h...
of 600, change:
available commands.  After adjusting the kernel to match how you have
controller        aha0    at isa? port "IO_AHA0" bio irq 11 drq 5 vector ahaintr
If you need to know the current registers, use
Reported by: Bob Beaulieu ezeztravel
Linux is distributed by several groups that make their own set of
access to your printers remotely, remote users will not get those lim-
contributions under this license.       Code under the GPL also goes
this is not run, then only routes which are statically defined (ie.
MASTER_SITES= crl.dec/pub/X11/contrib/applications/
2.  as a "server" , i.e. your machine is located on the network and
printing something.  To print with the LPD system, you use the command
Routing tables
It is important to understand that although the CPU always releases
-m Send mail after completing the print job.  With this option, the
When the original IBM PC was designed, IBM elected to use both DMA and
Data transfer rate is 160kB/s.
like ``Slackware'' or ``Yggdrasil''. The distributions are available
use a technique called zone bit recording. The idea is that on the
way that you created the boot floppy ``the beginning of this guide''.
automatically when you reboot. This is only necessary on the Kerberos
devices are not normally serial devices because most fixed disk
So: don't use spare sectoring, bad block remapping or whatever it may
o  Try "ifconfig sl0" to see your interface status.  I get:
4. The name of the author may not be used to endorse or promote products
There is only one sure way to do accurate accounting.  Get a printer
<username> to su to root if the necessary entries are in the .klogin
FreeBSD ports still use the tarball mechanism, but use a ``skeleton''
REV7 3R1" "type 1 removable SCSI 1" "density code 0x11, 1024-byte
it comes to extraction, and the rest will be just left in ${DISTDIR}
example is the files that comprise these handbook pages-they have been
But, if there is a text filter for the plain text jobs, then LPD
output at\13
example above.
(DLAB==1) This value will be divided from the master
You will be prompted for the database Master Password.
        By default this part behaves similar to the NS16550A, but an
o  A full compliment of C, C++ and Fortran development tools.  Many